Electronics Forum | Wed Jul 03 07:49:35 EDT 2019 | daniel_marquette
Got it. Servo tuning is new to us, so we'll try it. When you propose to swap the Y axis amps, do you refer to the driver that controls the Y motors? Thanks,
Electronics Forum | Thu Oct 26 10:48:17 EDT 2023 | bobpan
It depends on the motherboard that you have. Some dont have a battery but have a Dallas BRam chip. Bob
Electronics Forum | Mon Feb 05 13:32:43 EST 2024 | bobpan
email me and i can send them to you. My email is on http://www.precision-repairs.com
Electronics Forum | Tue Jun 12 15:12:47 EDT 2012 | tanderson
We clean (using a pencil eraser) the fiducials on all our PCBs before processing them through a QUAD QSP-2. We're discussing pcb's with our fabricator to see if they have recommendations. Some of our Engineers believe it is the QUAD that's the proble
Electronics Forum | Wed Jul 03 08:10:34 EDT 2019 | bobpan
The amp is mounted on the back side and is black. 4 total mounted for x and y axis.....swap the 2 that are y axis amps. If you have never servo tuned before on a quad machine you not going to be able to do it. There is way to many things that you nee
Electronics Forum | Fri Apr 07 17:44:17 EDT 2006 | bobpan
You can either optimize both boards from the very start to the same table top or you can assign the feeders under configure tabletop to the same spot that they were in when you optimized the first program. Remember that you can optimize many differen
Electronics Forum | Fri Apr 21 23:28:54 EDT 2006 | SD
Sounds like you have a non-IQ system? If you can, get one! It makes life much easier. Costly, though! Anyway, as stated above, your best bet is to assign multiple boards to the same table top. If the two boards are 99% similar, use a full opti
Electronics Forum | Mon Apr 24 07:37:57 EDT 2006 | craig_83
We have the IQ system. The problem that I was having is that when I load one board to the other, I want to avoid the table top changeovers. So I figure if I can make certain tabletops to run certain boards the changeovers would be much less. I though
Electronics Forum | Tue Aug 10 15:21:46 EDT 2010 | tanderson
I'm having problems with Quad QSP-2 pick n place machines recognizing fiducials. We are cleaning the fiducials, but that's tedious and time consuming ( I don't know anyone who routinely cleans them). We have solder mask clearance around the fiducials
Electronics Forum | Tue May 07 13:42:45 EDT 2013 | tanderson
These are dropped/mis-placed by the machines. We have older Quad QSP-2's. My concern is it's easy for the operators to overlook the dropped parts, keep running the job and when they're done, throw away parts (inexpensive resistors aren't such an issu
